Author Topic: About the launching pad  (Read 3441 times)

starprospect

  • Just joined training
  • *
  • Posts: 47
About the launching pad
« on: March 14, 2011, 10:02:55 PM »
Hello everyone, I have a question about the launching pad.

The launching pad have two "n" sharp objects which place beside the main engines.

What is that???

Is it use to start the engines???

Thank you!

Pocci

  • Shuttle Pilot
  • *****
  • Posts: 616
Re: About the launching pad
« Reply #1 on: March 15, 2011, 02:11:36 AM »
Sorry, I am not sure what you are talking about.
Do you mean the two little flat towers, with the round top that end just at the top surface of the rear part of the wings?

/Armin
Coordinator of 1st multiplayer Launch on 2009-05-30

Spacewalker

  • Mission Specialist
  • ****
  • Posts: 272
Re: About the launching pad
« Reply #2 on: March 15, 2011, 02:29:28 AM »
They are called "Tail Service Masts" (TSM). The following is quoted from: http://science.ksc.nasa.gov/shuttle/technology/sts-newsref/stsover-prep.html#stsover-mlp

Quote
On each side of the main engine exhaust hole there are two large devices called Tail Service Masts. They are 15 ft. long, 9 ft. wide and rise 31 ft. above the MLP deck. Their function is to provide umbilical connections for liquid oxygen and liquid hydrogen lines to fuel the external tank from storage tanks adjacent to the launch pad. Other umbilical lines carry helium and nitrogen, as well as ground electrical power and connections for vehicle data and communications.

At launch, the umbilicals are pulled away from the Shuttle and retracted into the masts where protective hoods rotate closed to protect the umbilicals from possible exhaust flame damage.


starprospect

  • Just joined training
  • *
  • Posts: 47
Re: About the launching pad
« Reply #3 on: March 15, 2011, 02:48:01 PM »
Sorry, I am not sure what you are talking about.
Do you mean the two little flat towers, with the round top that end just at the top surface of the rear part of the wings?

/Armin

YA...

Thank you for you all provided me the information ;D